Sheet Extrusion Line

Home > Product Category > Extrusion Line > Sheet Extrusion Line

Extrusion Line (For Thin Sheet)

Extrusion Line (For Thick Sheet)

	Custom engineered roll stack designs include adjustable, vertical, 45" angled and horizontal models. Wide range of embossing & polishing calenders to meet almost all the numberous and varied production requirement. Quick heat transfer characteristics and temperature accross the whole roll width.
Roll Stack For Thick Sheet		Roll Stack For Thin Sheet

Extrusion Line - Sheet Extrusion Line - Edge Trimming & Slitting Unit

Water Cooling Temperature Controller (For Roll Stack)

NDC Thickness Gauging System

View Thickness Gauging System

Manual Control or Automatic Control Incorporated to Auto Die.

Other Options Available :

Fully Automatic and Integrated Gravimetric System

Edge Trim Recycling with Full Automation

Multi-Component Blenders

Lamination Systems

Continuous Screen Changers

Corona Surface Treaters

Dehumidifiers

Chillers

Options for T-DIE, Feed Block and Gear Pump :


		Multi-Manifold Coextrusion Die
		A flexible lip adjusting system to provide an uninterrupted flow surface in the lip area. Closely spaced lip adjusting bolts act against polymer pressure and the natural spring of the metal. The lip is flexed to adjust the gap, the bolts always remaining in compression eliminate thread slack and resulting loss of sensitivity inherent to push-pull systems.

		Ultraflow Coextrusion Feedblock
		All stainless steel construction - Provides corrosion resistance Split body design - Ease of cleaning Streamlined flow surface - Minimizes residence time - Reduces gel formation Modular design - Expandable from two to seven layers Flow turning modules - Uniformly distributes layers Optional valves - Direct skin layer from top to bottom Removable flow spool for layer sequencing is available




		Multi-Manifold Sheet Dies
		Multi-manifold dies are the newest generation of sheet dies. These advanced products can be supplied with a restrictor bar for each extrusion layer to accommodate major shifts in viscosity. Multi-manifold sheet dies provide very polymer usage without sacrificing physical properties

		Feed Block
		Cloeren's patented three-layer Variable Geometry (VG™) Feedblocks offer optimum flexibility for flat coextrusion applications. Externally adjusting vanes enables processors to adjust for layer-structure changes without interrupting operations. Its unique distribution pins optimize layer uniformity.




		Gear Pump
		The optimized flow inlet and outlet geometries of this pump, makes it suitable for a wide range of applications. The bearings and the channels are designed to minimize the residence time and for a stress free flow of the melt through the pump. Therefore the pump can be used in applications with thermosensitive, transparent and as well easy degradable polymers.


		Gear Pump
		Eliminates discharge fluctuations caused by variations of the pressure and/or viscosity Reliability of the process enhanced Increased productivity Closer tolerances band Material savings High reliability of the process